Installation of hair accessories and use for fishing carp, carp, crucian carp

Carp, especially trophy carp, is very careful and accurate and it is quite difficult to catch large fish. But the right tackle allows you to provide an excellent result. Hair rig – best suited for catching carp and carp, also catch carp and bream with hair. Moreover, it is not at all difficult to assemble this tackle with your own hands.
Installation of hair accessories on a sliding ring [/ caption]

Advantages and Disadvantages of Hair Rig

When using a hair rig, the bait is not put on the hook, but on a short leash that is near it – the so-called “hair”. When the carp swallows the bait, it also sucks in the hook, which allows it to detect the fish. Hair attachment was invented in England. Now she is one of the most popular with fishermen around the world. But it has both advantages and disadvantages. Main advantages:

1. If the bait is on the hook, there is a great chance that the fish will prick on the sting. After that, the careful carp will simply spit out the nozzle. If a hair tackle is used, this practically does not happen.
2. The bait is securely on the hair and does not fly off even during the casting.
3. The sting detects the lower lip of the fish. So the possibility of inflicting injury on carp is minimal. This is an important moment for athletes, when the fish, after being caught, must be released back into the reservoir.
4. You can do your own hair montage. This does not require expensive materials and fixtures.
5. Carp or carp are well spotted. There are practically no empty bites. Often, during fishing with this tackle, self-chopping is noted – the sting pierces the lip of the fish when it tries to get rid of the hook.

The
hair rig almost always detects the fish by the lip, and therefore the risk of unnecessary injury is minimal [/ caption] The disadvantages include the following points:

1. An additional leash departs from the hook, albeit small, but this increases the possibility of entanglement of the tackle.
2. This rig often clings to aquatic vegetation, since the point of the hook is not covered by anything. Therefore, when fishing in overgrown reservoirs, you need to either knit special assemblies, or prepare for frequent flails and bandaging of leashes.

How to make a snap

Before knitting hair accessories, you need to prepare all the necessary materials:

• hooks;
• cord or leash material;
• scissors;
• cambric or silicone heat shrink tubing.

Leader material Sufix [/ caption]

Choosing hooks

All fishermen, and especially carp anglers, have their own favorite hooks, which they usually use. What you need to pay attention to when choosing a hook for mounting a hair:

1. With an elongated, straight sting and a forend parallel to each other – excellent hooks for sinking baits in clear waters.
2. With a shortened straight sting and forend parallel to each other – best suited for carp on rivers and for fishing on pressed toll rates.
3. With an elongated forend – they are considered universal and are used on any water bodies. Perfectly hook carp, as they easily turn in the mouth.
4. With a small curved forend – used for a clean bottom. They effectively hook the fish, but often injure carp during forced fishing, this must be taken into account when fishing.
5. With an even small forend and an inward curved sting – can be used for fishing in difficult conditions, when there are many stones and shells at the bottom.

The hook for the hair rig is matched to the bait, if boilies are used, then it is worth choosing such a size when the distance from the tip to the forend will correspond to half the size of the ball. This condition must be observed when attaching other round baits.
Mounting the boilie on the hair on a hook concave inward [/ caption]

Hair mounting material and length

The softer the cord used to knit the tackle, the less likely it is to frighten off cautious fish. The disadvantage of these leads is that they tend to get confused when casting. With this in mind, you need to choose the optimal leash material for fishing in certain conditions.

Recommendation: To prevent the soft line from getting tangled during casts, it is coated with a special gel, for example, Kryston Superstiff. This makes the cord stiff, and when it gets into the water, the top coat dissolves.

The size of the hair will determine how reliably the fish will be hooked in the future. If it is small, the sting will pierce the upper lip of the carp and may fly out during striking. With very long hair, the tackle will tend to get tangled when casting. Moreover, the sting usually pierces one of the corners of the lower lip and is not securely held, that is, there are many descents. The size of the hair will depend on the type of hook chosen and the size of the bait. It is worth empirically choosing a nozzle for a certain hook. First, the hair installation is knitted so that the distance from the hook to the bait is within 5-10 mm. With idle bites, this distance can be increased or decreased.

How to make hair montage on carp simply and quickly, without cambric and heat shrinkage – video instruction:

https://youtu.be/BegZNJPTat4

Is a rubber tube required

The heat-shrinkable tube is put on the hook so that the hair tackle does not get tangled on the forend. That is, after casting, the rig will be at the bottom, in the desired position. In this case, the maximum opportunity for effective fish hooking appears. But, at the same time, due to the cambric on the fore-end, the likelihood of carp or carp coming off when fishing is increased. If the tube is not installed, the waste will be significantly reduced. Soluble PVA tape is often used as an alternative, it allows you to ensure the normal position of the hair when casting and immediately after lowering the tackle.

Baits and lures

Best of all, carp / common carp and crucian carp peck on a hair rig
when using boilies. This is a hard bait, so it is very difficult to bait it straight onto the hook. However, other attachments are often chosen for this tackle:

• potatoes;
• Styrofoam;
• peas;
• pearl barley;
• corn.

Canned corn and peas are the best attachment for hair except boilies [/ caption]

Sandwiches made from various baits perform well. For example, you can attach peas, corn, and another pea to your hair.

To attach a boilie or other bait, you need to pierce it with a special needle, pick up the loop, which is located at the end of the hair, and thread it through the nozzle. After that, a stopper is installed in the loop and the boilie moves tightly towards it.

How to tie the installation of hair accessories – step by step instructions with photos and videos

Installation of the simplest hair accessories is knitted as follows:

1. First, you need a leash material about 10-20 cm long. A small loop is knitted at the end. A stopper is then threaded into it.
2. Next, a hook is knitted. In this case, the required hair size is selected. The most commonly used knotless knot.
3. Now you need to cut a piece of rubber tube about 5 mm in size and thread the leash material through it.
4. Now you need to attach the tube to the hook shank. Moreover, it must be in the center of the forend.
5. Next, a leash is attached at the end.

The installation of the hair tackle has been completed. You just need to check if it is assembled correctly. For what it is placed in the palm of your hand and stretched. The hook is obliged to unfold with a sting downward. This rig will work as efficiently as possible. How to knit a hair rig for a carp with your own hands, see the video: https://youtu.be/DV2QhcSAtcE

Pop-Up Boilie Tackle

With the right tackle, floating boilies can get better results than a sinking nozzle with a classic installation. Pop-Up is often used when fishing in muddy waters. This attachment does not get bogged down in soft ground and is therefore accessible to fish. Features of mounting for fishing on Pop-Up:

1. You will need 30 cm of leash material, while one end is cleared from the shell by about 10-15 cm.
2. The loop is tied to fix the Pop-Up.
3. With the help of a needle, the boilie is put on the hair.
4. A tube is put on the leash and placed on the center of the forearm. Adjustable hair size.
5. The hook is knitted.

The
floating boilie can be mounted on the line [/ caption]

To make the rig more catchy, you can separately add PVA bags to it. The leash is threaded through it with a needle.

How to make a hair rig for a feeder when fishing on a Pop-Up is shown in detail in this video: https://youtu.be/C-UoSriD-tk

Hair catching tactics

As a rule, when fishing for carp, 3-4 rods are installed. In this case, the chances of a great catch are greatly increased. If a hair harness is installed, then jogging is usually not required, especially when the spring is deafly mounted. The fish, trying to get rid of the bait, independently plunges the sting into the lip. Editing the “hair” works as follows:

1. At first, it is advised to feed the fishing spot well. For this, you can use canned corn with various attractants. Moreover, you need not to overfeed the carp, otherwise it will not peck at the boilie. It is recommended to feed in small portions once an hour.
2. The bait is put on the hair. Often they additionally use the same corn, or peas.
3. The tackle is thrown at the intended location of the fish. As a rule, it lives in snags or near aquatic vegetation.
4. When the tackle falls to the bottom, they expect a bite. If the fish swallows the boilie, it will feel the hook behind it and try to get rid of it. At this time, self-trimming occurs.
5. After that, the carp can be pulled out of the water.

How the hair rig works when fishing for carp, see this video: https://youtu.be/1AfarjKubgQ

Frequent mistakes of fishermen

The main mistake is the wrong choice of the hook number, taking into account the bait. Beginners often miss this point altogether. You can fish with the wrong hook, but the number of idle bites increases. Another mistake is fitting a very long or short hair rig. This also reduces the percentage of fishing efficiency, since there is no self-hooking of the fish. Beginners should follow all the recommendations of experienced fishermen when choosing a hair length. At paid rates, it makes sense to install a longer leash, since the fish density is very high here. In wild waters, on the other hand, less hair is required. Fitting a hair rig is most effective when fishing for carp and carp. Thanks to him, you can catch a really trophy fish. The rig does not scare the prey, since the hook is located separately from the bait,therefore, the number of bites increases significantly.

Поделиться ссылкой: