What is the difference between a feeder and a donkey and a spinning rod: a comparative table

Ловля на фидер

There are no universal rods for fishing. Depending on the type of fish caught and fishing conditions, a specific rod and equipment are selected. But the same fish can be caught with different tackles, depending on the capabilities of the angler and the need. Feeder , donka and
spinning, similar to an uninitiated observer at first glance
,
have significant differences on closer inspection. The
What is the difference between a feeder and a donkey and a spinning rod: a comparative tablefeeder always implies the presence of a rod, while the donk can be a simple reel attachment – this is the first difference [/ caption]

What is the difference between a feeder and a donk in the tackle itself, as well as tactics, technique and equipment

Novice fishermen rarely see the difference between a donkey and a feeder. However, there are differences both in the equipment and in the fishing technique.

Tooling differences

Feeder tackle differs from donkey in quality and rod length. If you can even use an ordinary stick for the donkey, then a special rod is required for the feeder tackle
. Its length is from 2.1 meters to 4.2 meters.
What is the difference between a feeder and a donkey and a spinning rod: a comparative tableQuivertips are interchangeable tips for feeder rods, they are not used in the bottom ones [/ caption] The rod consists of several parts. Most often it is a plug-type rod, consisting of 2 – 3 parts. Rod manufacturers also produce telescopic blanks. An important part of the feeder is the top (
quivertip ). The set includes 3-5 pieces. It is the quivertip that gives the bite signal.
What is the difference between a feeder and a donkey and a spinning rod: a comparative tableFeeder tackle involves the use of a reel and a progressive rod [/ caption] The next difference is in the handle. With a feeder, it is no different from the grips of other fishing rods. In the case of a donkey, it is weighted down or provided with a thorn. This is done to secure the rod to the shore.

Differences in fishing tactics

Fishing on a donk consists in casting several rods and baiting fish over a large area. Reloads are rarely done, after about an hour. It is not uncommon for fishermen to leave their fishing rods until the middle of the night.
Fishing with a feeder means feeding fish in one place and regularly re-casting the rod.
What is the difference between a feeder and a donkey and a spinning rod: a comparative tableFishing on the feeder involves the use of a feeder in order to create a feeding spot at the bottom of the reservoir [/ caption]

Differences in technique

A fisherman on a donkey chooses a fishing spot and throws several rods in different places. After casting, the fishing rods are left alone, and the fisherman is waiting for a bite.
What is the difference between a feeder and a donkey and a spinning rod: a comparative tableDonka can be the most primitive – a rod (or without it at all), a reel, a hook and a signaling device [/ caption] Feederist initially throws only a feeder with bait … After lowering it to the bottom, the bait is shaken out with a sharp movement.
The feeding trough is thrown 3-4 times, forming a feed spot.
What is the difference between a feeder and a donkey and a spinning rod: a comparative tableThe feeding trough is a purely feeder element of the tackle [/ caption] After that, a leash with a hook is attached to the trough. Casting is done only in the stern spot. If there is no bite, then after 20 minutes the bait is checked.
What is the difference between a feeder and a donkey and a spinning rod: a comparative tableFeederist nowhere without a feeder [/ caption]

Tooling differences

The donka is equipped with a self-trimming harness. It includes a load, several leashes with hooks and a spring with feed. A thick substance is used as bait. Often a piece of cake is placed in the spring. The
What is the difference between a feeder and a donkey and a spinning rod: a comparative tablespring is a symbiosis of the feeder and the donkey [/ caption] A bell is used as a bite indicator at the donkey. The combination of a self-tacking rig and an audible alarm allows the angler to service multiple rods. Only the feeder and one hook (much less often several) are attached to the feeder. The easiest way to attach a rig to the main line of the
Gardner paternoster… Installation includes a feeder and a hook. The peculiarity of this attachment is that the hook is located on a longer line segment than the feeder.
What is the difference between a feeder and a donkey and a spinning rod: a comparative tableGardner loop [/ caption] It can be knitted either separately or on the main line. If the workpiece is made separately, then it is attached to the main equipment with a loop-to-loop knot. The basic principle of paternoster formation is as follows:

  1. A small loop is formed at the end of the line for attaching a leash with a hook.
  2. A loop 10-15 cm long is formed at a distance of 20 cm. A feeder will be attached to it. If it is attached with a swivel, then we put it on the fishing line immediately, before the loop is formed.
  3. When knitting a rig separately, a loop is formed at the free end of the line to connect to the main line.

All nodes are made surgical with 3-5 turns. To prevent the line from burning, it is moistened with water before tightening the knot. Donk fishing depends on luck. Using a feeder, you can always catch fish, if it is, of course, in the reservoir. Feeder fishing is more active and more interesting than fishing with a donkey. We can say that she is more “smart”.

What is the difference between a feeder and a donkey:

https://youtu.be/nP89GzVLnNw

What is the difference between a feeder and spinning in the tackle itself, tactics, technique and equipment

If it is still possible to distinguish between the donk and the feeder at once, then this will not work with spinning.

Tooling differences

Visually, the two rods are similar. The feeder differs from the spinning rod by a larger number of rings and a replaceable brightly colored tip. Also on the feeder is the tulip and rings of a wider diameter than on the spinning blank. The feeder rod comes with 3 tips, differing in rigidity.
What is the difference between a feeder and a donkey and a spinning rod: a comparative tableThere are fewer rings on the spinning rod and they are smaller in diameter than on the feeder tackle – one of the differences between the two main types of freshwater fish fishing [/ caption]

Differences in tactics

Unlike a feeder, a spinning rod involves the active posting of the bait in the water column or at the bottom. Groundbait is not required, waiting at one point is not required. Spinning fishing is a sport. It does not even imply a short rest. The fisherman needs to constantly throw the bait and pull it towards him.

Active search – spinning, active feed – feeder, passive waiting – donka: the difference between gear is obvious.

The speed and manner of escorting is determined by the type of reservoir, the current and the type of fish.

The difference in rigging

When fishing with a feeder, current feeders use a
braided line . It is tighter and does not tear as often as mono. Spinning rods are also often equipped with braided lines, it better transfers the bite of fish to the rod. When catching predatory species, metal
leashes are used , made of a thin cable or guitar string, or leash material.
What is the difference between a feeder and a donkey and a spinning rod: a comparative tableTungsten leash – spinning version [/ caption] In the feeder, leashes, if used, are only
made of fluorocarbon to reduce the visibility of the rig.
What is the difference between a feeder and a donkey and a spinning rod: a comparative tableFluorocarbon leads are used by anglers in almost all types of fishing [/ caption]

Spinning rods – often metal, tungsten and other types of leads to minimize the number of cuts by pike and walleye. Feeder – fluor to reduce visibility and increase the number of bites.

If, when using a feeder, preference is given to natural baits, then when fishing with a spinning rod, artificial baits are used:

Differences in the coil

Only spinning coils are placed on the feeder
. On spinning, both spinning and
multiplier reels are used . Inertial reels can also be used on a spinning rod, but their use requires experience with them. If used improperly, a “beard” can form from the line, which will complicate fishing.
What is the difference between a feeder and a donkey and a spinning rod: a comparative table“Cartoons” are put only on spinning rods [/ caption] Spinning requires more strength for fishing. The feeder, although it belongs to active types of fishing, allows you to relax on the shore of the reservoir.

Is it possible to replace the feeder with a spinning or donkey and in other variations of rods

You can replace the donk or spinning rod with a feeder rod. But the opposite will not work. The main difference between the feeder is the quivertip. It is not available on other rod variations. If a fisherman wants to not only catch fish while fishing, but also to enjoy fishing, then you need to choose a rod that matches the chosen fishing style.

If we talk about a universal feeder rod, then a blank with a dough up to 100 grams is suitable for fishing in any body of water. However, it is better to purchase 2-3 tackles with different indicators. The same situation is with spinning. If we consider a universal blank, suitable for fishing both at the bottom and in the water column, then you can take a closer look at the Gorynych Plyuss rod from the Volzhanka company. The blank comes with 3 quivertips of different stiffness. This allows you to use it as a donk, and as a feeder, and as a spinning rod.

Comparison table: let’s try to compare feeder, donk and spinning

FeederDonkaSpinning
RodTelescopic or plug-in type with flexible tip (quivertip) and a large number of rings (from 7 pcs.).Any rod can be used. From simple bamboo blank to telescopic.Telescopic, but more often plug-in. Number of rings 5 ​​- 6 pcs. 2 meters of blank.
RiggingFeeder and leash with hook.Load or feeder, 3-4 leashes with hooks.Artificial bait.
TacticsComplementary feeding of fish in one place, leisurely fishing with constant casting of equipment.Throwing bottom equipment over a large area. Fishing rods are checked no earlier than an hour later.Casting the bait and its posting in the water column.
TechniqueAt the beginning of the fishing, a stern spot is created. The tackle is thrown in only one place. After a bite or after 20 minutes, the bait is checked and, if necessary, changed.Fish are fed on a large territory. After casting the tackle, the rod is fixed on the shore. A bell is attached to the fishing line to determine the bite. If there is no signal, the rods are checked in an hour.After casting the bait, the fisherman uses the handle of the reel to guide it through the water column. Depending on the type of fish, this can be uniform or chaotic.

Feeder fishing is different from other types. It is calmer than spinning and more active and meaningful than donk fishing. Using different leashes and bait on it, you can catch both small fish and large ones. The rig allows you to quickly respond to changing conditions and catch a catch any day.

Поделиться ссылкой:

Rate author
Add a comment