Fishing for trout in the winter on gutters and trays

Nowadays, fishing for trout in the winter on zherlitsy on paid and wild ponds is gaining an increasing number of adherents of this fishing. You can catch fish not only with this rig, but also with other promising fishing devices for ice fishing.
Trout is a beautiful fish that can be caught on the gut, but should be released as soon as possible [/ caption]

Advantages and disadvantages of trout fishing

Using a gutter for winter trout fishing has many advantages:

• no need to buy expensive artificial bait;
• ease of use;
• recreation infrastructure is developed on paid ponds;
• high efficiency of the tackle.

But the winter trout zerlitsa also has disadvantages:

• fine tuning of the rig is required, since the fish spits out the bait if it feels danger;
• it is difficult to determine the depth where the trout is;
• on paid ponds, limits are often set on the number of established girders.

Zerlitsa for trout is not much different from
zander and
pike [/ caption]

Best time to fish

Trout bites throughout the winter, but bites are observed more often in the first ice and before the flood. In the wilderness, the trout is in almost complete stupor. The weather greatly affects the nibble of this fish.

Note: Like many other fish species, rainbow trout are most active on warm days. There are no specific daily recommendations – the fish manifests itself throughout the whole day.

Where to look for trout on the pond

The fish can be found anywhere in a particular body of water. During the wilderness, to saturate the water with air, aerators are installed at many paid rates, since trout are sensitive to the presence of oxygen in the pond. Fishing near these devices is much more promising, although some anglers claim that fish that live far from these devices are much more active.
It’s easier to find trout parking spots on the paysite [/ caption]

Recommendation: The main difficulty is determining the depth where the fish is. If during fishing with artificial bait it is possible to examine all the water layers, then the nozzle on a stationary trap is often located outside the location of the trout flock. Therefore, it is worth installing a number of supplies, breaking through the entire promising horizon at once.

As a rule, trout runs not near the bottom, but in the floor of the water, however, with a significant depth of the reservoir, it is very difficult to determine the required horizon. Therefore, fishing for active bait is usually combined with girders. Thanks to the artificial nozzle, you can determine the water layer for trout fishing and lower the line on stationary stands to the required depth.

Types of girders

Trout, unlike other predatory fish, spits out a nozzle at any suspicion of danger, therefore the line must be adjusted to leave the vent so that the fish does not feel any resistance. Therefore, in addition to traditional models on the platform, other structures are often installed. The best trout gutters that can be installed in winter are:

1. In the American version, the spool is under water, so you can ensure an easier descent of the line. However, in our country, this rig is not popular because of its high cost, as well as because of its complex design, which greatly complicates the installation, and because of the inconvenience of fishing during severe frosts. American supply [/ caption]
2. Zherlitsa-changeling . This installation of a gutter for winter fishing can be built with your own hands. The rig is quite sensitive, while the line easily flies off the reel, so the trout often self-chops. Changeling supply [/ caption]
3. Delivery . At the heart of this rig is the rod, on which the fish is actively caught. It is mounted on a specially made stand. This rod needs to be watched, and when the tip is lowered, a sweep is required.

Gutter design

As a rule, fishermen use the classic versions with a base and a signaling flag, since these designs are available in any fishing store, they are not expensive, and installation is very simple. The standard device for the iris trout girdle is as follows:

1. Coil . It is installed on a stand and is fixed by means of a bracket. This piece of equipment is required: so that the reel can rotate with ease and have a large spool size. Often, fishermen paint half of the reel in a contrasting color, which allows them to see from a distance how the spool drops the line.
2. Foundation . Most often it is made of plastic and looks like a circle. A stand with a coil and a flag, which plays the role of a signaling device, are fixed to the base. There is also a radial slot in the platform, where the fishing line is passed. The flag is on – we run to the zherlitsa, but we are not in a hurry to perform the sweep [/ caption]
3. Lesk a. Most often, winter fishing line with a cross section of 0.20-0.25 mm is chosen for trout. The spool must be at least 25 meters.
4. Checkbox . It is usually made of a clock spring. A red flag made of waterproof material is installed at the tip.
5. Hook . Basically, when fishing for trout, single hooks number 4-8 are installed.
6. Leash . Its length should be no more than 0.5 meters, it is made of fluorocarbon with a section of 0.16-0.18 mm. The diameter will depend on the weight of the intended trout.
7. Weight . For this, a sliding pellet with a weight that is as low as possible is used.

Horizontal zerlitsa – supply for winter fishing [/ caption]

Used baits

Most often, shrimp is used as bait. To equip the girder with a boiled ice-cream nozzle, it is enough to put its tail on the hook. The carapace does not need to be removed. In addition to shrimp, the following baits are possible for equipping a trout supply:

• maggot ;
• paste for catching the iris; Trout paste [/ caption]
• bloodworm ;
• fish fillet pieces;
• worm;
• live bait.

Recommendation: Basically, as live bait,
bleak or
top water , about 4-6 cm in size, is used.

Self-made zerlitsa

Usually, the installation of the gutter when fishing for winter trout is done classic. This device has excellent resistance to strong winds and does not allow the hole to freeze, although the size in the assembled state is rather bulky. How to make a zherlitsa correctly – step by step instructions:

1. A hacksaw cuts a base from a plywood sheet. It is not necessary to make a rounded shape.
2. A hole is made at the base for the fishing line. A stand is installed from a steel corner and fixed to the platform using self-tapping screws.
3. A bracket is made from a spoke from a bicycle wheel.
4. The coil on the bracket is fixed to the base.
5. The spool can be made from a regular spool from the spool.
6. A bite alarm is made from a spring from a clock.
7. At the end, a red flag is fixed.
8. A fishing line is wound on the spool.
9. A weight is passed through.
10. A swivel with a carabiner is attached to the end of the line. The design of the gutter for fishing on the current [/ caption]
11. The leash is knitted with a hook and fixed to the main line in a loop-to-loop fashion.

Winter homemade trout gnarl [/ caption] https://youtu.be/i_nBnFFL_cY

Installation features

To correctly position the girder, the following steps must be followed:

• a hole is drilled;
• pieces of ice are removed;
• the depth is measured, preferably with a depth gauge;
• the rig is going;
• the required length of fishing line is wound, which, according to the fisherman, is optimal for successful fishing;
• make a bait attachment on a hook;
• the tackle is lowered into the water;
• the hole is slightly covered with snow.

Equipping the gutter and fishing for trout in winter for supplies: https://youtu.be/x4zv7JPZk2U

Fishing tactics

Today, the owners of paid trout reservoirs allow fishing with a limited number of rigs, while in Europe it is often allowed to install only one gutter. Therefore, the tackle must be properly installed, due to their small number. Trout runs in the pond all the time; you can catch it almost anywhere in the pond. If possible, then you should focus on the rest of the fishermen. Most often, trout is caught in several ways:

• they keep an eye on the girders all the time;
• set girders and go trolling.

With the first method, the chances of catching trout on the girder are small, since the fish is not often caught on its own. But you can take a predator with artificial bait, which is much more exciting. The strategy for catching fish on the girders consists of periodically rearranging the rig and changing the water layers to determine the location of the trout. In doing so, it is worth trying out various baits, since fish food preferences are unpredictable.

What to do during a bite? You should not expect that the fish will swallow the bait with high quality, try it, and then leave with it. When the trout has exhausted about 50 cm of fishing line, an urgent need to hook is needed. Trout is a very neat and tender fish, and therefore you should not wait long.

You need to fish out carefully, not forcing events, and at the same time, do not weaken the line. This predator has rather dense lips, and the hook is securely in them, but a strong trout often breaks the line, and if there are stones at the bottom, then the fish will most likely go to this place and it will not be easy to pull it out. Fishermen who are used to catching small perch or
small pike do not even know how strong a trout is in itself. Therefore, the hook must always be at hand, and the 150 mm hole sometimes turns out to be very small in order to easily get the fish out of it. At the same time, trout of various sizes are often in the same pond, and among the kilogram sizes there is sometimes a “treshka”, for this a fisherman must definitely prepare.

Fishing for trout in a paid pond with girders and stubs:

https://youtu.be/KEzrfYEYRfc Also, when fishing for trout, you need to be very careful and not make too much noise. The fish can easily get scared, leaving even inhabited areas of residence or from places to search for food. The noise is often provoked not only by the fisherman, but also by the trophy. The predator caught on the bait actively tries to leave, scaring away the whole flock by this. In order not to scare the iris, you need to fish it out as quickly as possible. Why do you need a fishing line that will allow you to do this.

Поделиться ссылкой: